150A-10-40V-12V-24V-current-limited-DC-motor-speed-controller-PWM-RS232-arduino

Description

We have several type of DC motor PWM controllers!
Simple forward or reversible version. up to 500A and 200V with programmable USART and other useful functions and more...

Please check our ebay store:
>>>Click here to see different versions and bulk prices of this controller<<<
www.dropbox.com/s/mgcxvzqtezcmtwl/HLX40100%20wiring.pdf?dl=0
^^^Donload the datasheet with this link^^^
Use it for trolley, outboard, electric bicycle, go-cart, boat and any other industrial application.
Just connect your battery and your motor to the M6 screw terminals set the maximum current with the small blue trimmer potentiometer on the board and you are ready to use.
Common parameters:
4 operation mode: normal potentiometer/magnetic hall throttle (with 0.5-4,5V output)/direct PWM input (0-95%)/ RC PWM receiver input 1,5ms +/-1ms
High efficiency power stage no need for heatsink but a fan can increase the output current.
Double thermal sensor on the PCB against the overheating and optional fan controll terminal for exteral fan cooling.
serial communication with RX TX input as an additional communication mode ore to use as a primary controll input.  For the communication protocoll please read the datasheet. Simple Arduino commands or adanced protocoll for more accurate detailed parameters.
One direction drive with regenerative braking (drive CW and regenerative brake CW)
Connection with high current M6 screws.
Default 500 Hz switching frequency
Duty cycle: 0-100% (available output voltage compared to the input)
Universal 0-5V speed controller input.
You can use either just the potentiometer , hall throttle, or any analoge voltage source like PLC output or PWM signap from uPC or RC receiver PWM signal.
Regenerative braking (you can brake the motor and get back all the kinetic energy into the battery)
For the highest safety the regenerative braking never
replaces the normal brake!
Adjustable output current limit 0-70, 0-100, 0-120A depending on the model version you choose
Peak current 200A.
Adjustable soft start (acceleration limit). 0-41sec.
Adjustable decceleration limit, turn on /off voltages (need to set throught the serial port)
Adjustable speed regulation and top speed settings
(need to set throught the serial port)
Dimensions: 104 x 97 x 29 mm 4,1"x 3,8" x1,1"
Minimum turn on supply voltage 6-60V DC
Maximal supply voltage 30-40-60V depending the model you choose. (For 12V choose the 30-40V, for 24V choose the 40V and for the 36-48V systems choose the 60V version)
Weight: 100g